VW Golf manuals

Volkswagen Golf Service & Repair Manual: Crankshaft dimensions

Risk of damage to bearing pedestals when the crankshaft is removed.If the bolts of the crankshaft bearing cap are loosened, the bearing pedestals of the cylinder block will be deformed, and damage to the bearings will result.Never remove the crankshaft.
Measuring the main bearing clearance is not possible with normal workshop equipment.
   
Honing dimension Conrod bearing journal diameter mm
Basic dimension 48.00 –0.022 –0.042
Renewing needle bearing in crankshaft
Only vehicles with a dual clutch gearbox Special tools and workshop equipment required     ...

Measuring axial clearance of crankshaft
Risk of damage to bearing pedestals when the crankshaft is removed.If the bolts of the crankshaft bearing cap are loosened, the bearing pedestals of the cylinder block will be deformed, ...

Other materials:

Noises from shock absorbers
Shock absorbers are often replaced because of noises (rumbling, etc.) experienced by the customer. Inspections on the test rig and in the vehicle have shown that in approx. 70 % of these cases there is no case for complaint. The replacement was not justi ...

Removing and installing valve, rubber valve
Ensure that the wheel rim is clean.     –  Insert new tyre valve with -VAS 6459--1-. –  Unscrew and remove valve insert. –  Infl ...

Warning and indicator lamps
First read and observe the introductory information and safety warnings  Lit up Possible cause Solution Engine oil level is too low. Switch off the engine. Check the engine oil level   . ...

© 2016-2026 Copyright www.vwgolf.org