Removing and installing dash panel vents
Special tools and workshop equipment
required
Front-end hook -3370
Removal wedge -3409
Removing
...
Conicity
Conicity is caused by a slight offset of the tread and/or
the belt (amounting to a few tenths of a millimetre) relative to
the geometric centre of the tyre. Taper is not visible and
cannot be measured with equipment available in the workshop.
& ...
Introduction
This chapter contains information on the following subjects:
→ Drink holders in the front centre console
→ Drink holders in the rear centre armrest
→ Drink holder in the rear side trim
Bottle holder
Bottle holders are located in the open stowage areas of t ...