Volkswagen Golf Service & Repair Manual: Clutch
- Assembly overview - dual clutch
- Removing dual clutch
- Installing dual clutch
- Renewing input shaft seal
- Renewing oil seal for inner input shaft
Adjusting clutch engagement
The position of the engagement bearings “K 1” and “K 2” must
only be adjusted after the following work:
Clutch has been renew ...
Assembly overview - dual clutch
1 -
Hinge mounting
For large engaging lever “K 1”
Cannot be renewed.
2 -
Ball pin
For small ...
Other materials:
Assembly overview - dash panel insert
1 -
Electrical connector
For dash panel insert
2 -
Dash panel insert -KX2-
With control unit in dash panel insert -J285-.
Dash panel insert must be renewed if warning lamp LED or
illumination ...
Removing and installing bonnet lock, RHD vehicle
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
–
Open bonnet.
–
Remove Bowden cable on mounting bracket ...
Fitting the rear towing eye
Fig. 248 Rear bumper on the right-hand
side: removing the cover
Fig. 249 Rear bumper on the right-hand
side: screwing in the towing eye
First read and observe the introductory information
and safety warningsThe towing eye is screwed into a threaded hole behind
a cover on the right of the ...
