| Removing |
| – | Remove glass panel → Chapter. |
| – | If drive is defective, remove glass panel → Chapter. |
| – | Pull self-adhesive insulation -3- off. |
| – | Remove bolts -2-. |
| – | Pull out cover upwards at an angle -arrows-. |
| Installing |
| – | Push cover onto assembly frame. |
| – | Tighten bolts -2-. |
| – | Attach self-adhesive insulation -3-. |
| Specified torques |
| Cover → Chapter |
Note| In the event of power failure, the sliding/tilting sunroof with glass panel can be moved using a commercially available hexagon key directly on the drive. |
| Considerable force must be used to turn the key because the drive is not decoupled from the gears. |
| – | Insert hexagon key into the bolt -3- of the drive -1-. |
| – | Turn the bolt -3- to close the glass panel. |
Removing and installing -J245-sliding sunroof adjustment control unit
Removing and installing sunroof roller blindRemoving and installing rear 3-point seat belt, 4-door model, without belt
tensioner
Removing
–
Remove rear shelf support
→ Chapter.
–
Remove outer rear seat belt guide anchor
→ Chapter.
–&n ...
Charging battery in support mode with battery charger -VAS 5900-
General notes:
The support mode provides the onboard supply with power when
the battery is removed or disconnected.
For further information, refer to the
→ operating manual VAS 5900.
The ...
Removing and installing rear side airbag with rear side airbag igniter
-N201-/-N202-
Removing
WARNING
Observe safety instructions for pyrotechnic
components
→ Chapter.
Observe the additional safety regu ...