The following actions must always be carried out in the given order in preparation for filling a tyre :

If you get a flat tyre, park your vehicle on a firm and level surface at a safe distance from the flow of traffic.

Switch on the electronic parking brake Braking, stopping and parking Brakes Parking .

Automatic gearbox: move the selector lever to position P Changing gear Changing gear Automatic gearbox see Automatic gearbox_0 Automatic gearbox see Changing gear_0 Automatic gearbox Manual gearbox see Changing gear_0 Manual gearbox .

Stop the engine and remove the key from the ignition Starting and stopping the engine Engine and ignition Ignition see Engine and ignition_0 .

Manual gearbox: select a gear Changing gear Changing gear Automatic gearbox see Automatic gearbox_0 Automatic gearbox see Changing gear_0 Automatic gearbox Manual gearbox see Changing gear_0 Manual gearbox .

Ensure that all vehicle occupants exit the vehicle and proceed to a safe position, e.g. behind the safety barrier.

Switch on the hazard warning lights and position the warning triangle In an emergency Emergency . Observe any legal requirements.

Check whether the puncture can be repaired with the breakdown set Breakdown set When not to use_2 The tyre sealant must not be used:.

When towing a trailer, unhitch the trailer from the vehicle and park it properly.

Remove any items of luggage from the luggage compartment.

Take the breakdown set out of the luggage compartment.

Take the sticker ② from the breakdown set and stick it on the dash panel within the driver's field of vision.

Do not remove foreign objects (e.g. screws or nails) from the tyre.

WARNING
Preparation
Sealing and inflating tyresIntroduction
This chapter contains information on the following subjects:
→ Centre cover
→ Wheel cover
→ Wheel bolt caps
Additional information and warnings:
Cleaning and caring for the vehicle exterior
Vehicle toolkit
Changing a wheel
Breakdown set
WARN ...
Assembly overview - drive shaft, triple roller joint AAR3300i
1 -
Bolt
Renew after removing
Loosening and tightening
→ Chapter
Before fitting, clean the threads in the CV joint using a thread
tap.
200 Nm +180°
2 - ...
Removing and installing Hall sender 3 -G300-
Removing
–
Release hose clips -1- and
-2-, and remove air pipe.
–
Disconnect electrical connector -1-.
...