Volkswagen Golf Service & Repair Manual: Changing headlights over from driving on right to driving on left (gas discharge headlights with dynamic high beam control and LED daytime running light)

Volkswagen Golf Service & Repair Manual / Electrical system / Lights, lamps, switches outside / Headlight / Changing headlights over from driving on right to driving on left (gas discharge headlights with dynamic high beam control and LED daytime running light)

If a right-hand drive vehicle is driven in a left-hand drive country, or vice versa, the headlights must be converted. This is necessary in order to avoid dazzling oncoming traffic with the asymmetric low beam headlights.

Note

The conversion from driving on left to driving on right, or vice versa, is performed by means of the infotainment system.

It is only permissible to make use of the headlight converter for a short period of time. When permanently driving in the respective country during a longer period of time, suitable headlights need to be installed according to valid specifications.

–	On the display unit for front information display and operating unit control unit -J685-, press button CAR.

–	Press function buttons Setup and Light.

–	Perform adjustment in menu “Light Settings”.

Changing headlights over from driving on right to driving on left (gas discharge headlights for cornering light and LED daytime running light)

If a right-hand drive vehicle is driven in a left-hand drive country, or vice versa, the headlights must be converted. This is necessary in order to avoid dazzling on ...

Changing headlights over from driving on right to driving on left, LED headlights

If a right-hand drive vehicle is driven in a left-hand drive country, or vice versa, the headlights must be converted. This is necessary in order to avoid dazzling on ...

Other materials:

Assembly overview - brake servo/brake master cylinder, LHD vehicles
Note Only use new brake fluid conforming to VW standard (VW 501 14). 1 - Self-locking hexagon nut Always renew after removing Bolting sequence U ...

Removing and installing charge pressure positioner -V465-
Removing – Switch off ignition. – Disconnect electrical connector -1-. – Remove securing clip -2-. –&n ...

Performance figures
First read and observe the introductory information and safety warnings For reasons of vehicle registration and vehicle taxation, the power output and performance of some engines may vary in some countries from the information given in this booklet. Petrol engines ...