VW Golf manuals

Volkswagen Golf Service & Repair Manual: Changing headlights over from driving on right to driving on left, LED headlights

Volkswagen Golf Service & Repair Manual / Electrical system / Lights, lamps, switches outside / Headlight / Changing headlights over from driving on right to driving on left, LED headlights

If a right-hand drive vehicle is driven in a left-hand drive country, or vice versa, the headlights must be converted. This is necessary in order to avoid dazzling oncoming traffic with the asymmetric low beam headlights.
  Note
The conversion from driving on left to driving on right, or vice versa, is performed by means of the infotainment system.
It is only permissible to make use of the headlight converter for a short period of time. When permanently driving in the respective country during a longer period of time, suitable headlights need to be installed according to valid specifications.
–  On the display unit for front information display and operating unit control unit -J685-, press button CAR.
–  Press function buttons Setup and Light.
–  Perform adjustment in menu “Light Settings”.
   
Changing headlights over from driving on left to driving on right (dual halogen headlights)
If an RHD vehicle is driven in a left-traffic country, or vice versa, the headlights do not need to be adapted in any way.
   
Changing headlights over from driving on right to driving on left (gas discharge headlights with dynamic high beam control and LED daytime running light)
If a right-hand drive vehicle is driven in a left-hand drive country, or vice versa, the headlights must be converted. This is necessary in order to avoid dazzling on ...

Changing headlights over from driving on left to driving on right (gas discharge headlights)
If a right-hand drive vehicle is driven in a left-hand drive country, or vice versa, the headlights must be converted. This is necessary in order to avoid dazzling on ...

Other materials:

Overview of fitting locations
Overview of fitting locations - ABS/ESP 1 -  ABS control unit -J104- Installation location: on hydraulic unit, on passenger side of engine compartment. Do not separate connector before successfully completing self-diagn ...

Removing and installing oil pressure switch for reduced oil pressure -F378-
Special tools and workshop equipment required     Jointed wrench 24 mm -T40175- Removing –  Pull activated charcoal filter solenoid valve 1 -N80--3- ...

Introduction
This chapter contains information on the following subjects:  → Stowage  → Contents Observe any country-specific legislation when securing your vehicle in the event of a breakdown. Additional information and warnings: Preparation for working in the engine compartment ...

© 2016-2026 Copyright www.vwgolf.org