Volkswagen Golf Service & Repair Manual: Assembly overview – Blind Spot Monitor (Blind Spot Detection)
| 1 - | Blind Spot Monitor warning lamp in left exterior mirror -K303- |
| Removing and installing → Chapter |
| 2 - | Blind Spot Monitor warning lamp in right exterior mirror -K304- |
| Removing and installing → Chapter |
| 3 - | Bracket |
| 4 - | Nut |
| 6 Nm |
| 5 - | Electrical connector |
| 6 - | Blind Spot Monitor control unit -J1086- |
| Master |
| Removing and installing → Chapter |
| 7 - | Bracket |
| Lower contact point |
| 8 - | Bolt |
| 2 Nm |
| 9 - | Bolt |
| 2 Nm |
| 10 - | Blind Spot Monitor control unit 2 -J1087- |
| Slave |
| Removing and installing → Chapter |
| 11 - | Electrical connector |
| 12 - | Nut |
| 2 Nm |
| 13 - | Bracket |
|
Removing and installing Blind Spot Monitor control unit J1086/J1087
Removing
–
Disconnect electrical connector -2-.
–
Unscrew nut -1 ...
Other materials:
Removing and installing auxiliary heater
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410- (4…20 Nm)
Hose clamps, up to 25 mm -3094-
...
Removing automatic distance control unit from and installing on retaining
plate, variant 2
Note
If the automatic distance control unit -J428- is renewed,
start the respective function → Vehicle
diagnostic tester.
Special tools and workshop equipment
required
...
Assembly overview - glove compartment
1 -
Glove compartment
Removing and installing
→ Chapter
2 -
Damper element
For glove compartment lid
With glove compartment light switch -E26-
Removing and installing
→ Chapter
3 -&nbs ...
