Volkswagen Golf Service & Repair Manual: Air duct
| Assembly overview - air duct and air
distribution in passenger compartment |
| The assembly overview for air duct and air distribution is
identical with the respective assembly overview for vehicles
with air conditioning system
→ Chapter. |
|
|
|
| Removing and installing driver side
footwell vents |
| Removal and installation are identical with procedure for
vehicles with air conditioning system
→ Chapter. |
|
|
|
| Removing and installing front passenger
side footwell vents |
| Removal and installation are identical with procedure for
vehicles with air conditioning system
→ Chapter. |
|
|
|
| Removing and installing rear footwell vent |
| Removal and installation are identical with procedure for
vehicles with air conditioning system
→ Chapter. |
|
| Removing and installing fresh air intake |
| Removal and installation are identical with procedure for
vehicles with air conditioning system
→ Chapter. |
|
|
|
| Removing and installing cover for fresh
air intake |
| Removal and installation are identical with procedure for
vehicles with air conditioning system
→ Chapter. |
|
|
|
| Removing and installing air intake duct |
| Removal and installation are identical with procedure for
vehicles with air conditioning system
→ Chapter. |
|
|
|
| Checking exhaust ventilation for passenger
compartment |
| Checking is the same as for a vehicle with air conditioning
system
→ Chapter. |
|
|
|
| Removing and installing exhaust
ventilation for passenger compartment |
| Removal and installation are identical with procedure for
vehicles with air conditioning system
→ Chapter. |
|
|
|
| Removing and installing air duct for
defroster vent |
| Removal and installation are identical with procedure for
vehicles with air conditioning system
→ Chapter. |
|
|
|
| Removing and installing air duct for
centre dash panel vent |
| Removal and installation are identical with procedure for
vehicles with air conditioning system
→ Chapter. |
|
|
|
It is not necessary to extract the refrigerant and to remove
or disassemble the expansion valve and the evaporator. Further
procedure is identical with procedure for vehicles wi ...
Overview of control and display unit
1 -
Heated driver seat regulator
Optional
Seat heater has 3 heat settings. Current setting is shown b ...
Other materials:
Removing and installing ESP sensor unit -G419-
The lateral acceleration sender -G200-, the yaw rate sender
-G202- and the longitudinal acceleration sender -G251- are
installed together with the control unit for electromechanical
parking brake -J540- in the ABS control unit -J104-.
Th ...
Removing and installing tail light
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way.
If the event of a defective LED, the entire tail light needs
to be rene ...
Repairs to CAN bus wiring
An unshielded two-wire line -1-
and -2- with a cross section of
0.35 mm2 or 0.5 mm2
is used for CAN bus wiring.
The colour codes of the CAN bus wiring can be gleaned from
the following table:
...
© 2016-2026 Copyright www.vwgolf.org
Dismantling and assembling heater unit
Operating and display unit