First read and observe the introductory information
and safety warnings
| Display | Possible cause | Solution |
|---|---|---|
|
Any or all vehicle doors are open or not closed properly. | Do not drive
on! Open the appropriate vehicle door and then close it again. |
Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.
A symbol
in the instrument cluster display indicates
that a vehicle door is open or not closed properly. This symbol is also visible
when the ignition is switched off . The display will go out approximately 15 seconds
after all doors have been closed and the vehicle has been locked.
The symbol can differ depending on the version of the instrument cluster.
Introduction
Childproof lockAssembly overview - speed sensor on rear axle, all-wheel drive
1 -
ABS speed sensor
Clean inside surface of hole before inserting sensor
Coat inside surface with high-temperature paste -G 052 112 A3-
Removing and installing
→ Chapter
2 -
Bolt
...
Mounting tyre, run-flat tyres, ultra-high performance tyres
Only trained personnel may perform any assembly work on
run-flat tyres and ultra-high-performance tyres.
If fitted, check tyre pressure sensor using vehicle
diagnostic tester, and renew it as necessary.
–
...
Assembly overview - wheel housing trim, estate
Note
The illustration shows the wheel housing trim on the left side.
The right-hand side is similar (mirror image of left-hand side).
I: Vehicles without side padding
II: Vehicles with side padding
1 -
Wheel housing tri ...