Volkswagen Golf Owners Manual: Warning and indicator lamps

Volkswagen Golf Owners Manual / While driving / Starting the engine, changing gear and parking / Changing gear / Warning and indicator lamps

First read and observe the introductory information and safety warnings

Lit up	Possible cause	Solution
	Gearbox fault.	Do not drive on! Move the selector lever to position P and leave the gearbox to cool down. If the warning lamp does not go out, do not continue to drive. Seek expert assistance. Failure to do so can cause considerable damage to the gearbox .
	Brake pedal not depressed.	Fully depress the brake pedal. See also ACC (Adaptive Cruise Control) .
	Brake pedal not depressed.	To move the selector lever, depress the brake pedal. Please also refer to electronic parking brake .

Flashes	Possible cause	Solution
	The lock button in the selector lever is not engaged. The vehicle cannot drive off.	Engage the selector lever lock .

Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.

WARNING

Failure to observe illuminated warning lamps and text messages can lead to your vehicle breaking down in traffic, and can cause accident and serious injury.

Never ignore any illuminated warning lamps or text messages.

Stop the vehicle as soon as possible and when safe to do so.

If the vehicle is stationary or has to be parked for repairs, always park the vehicle at a safe distance from the road, switch on the hazard warning lights, switch off the engine and take other precautionary measures in order to warn traffic behind you.

NOTICE

Failure to observe illuminated indicator lamps and text messages can lead to your vehicle being damaged.

Introduction

This chapter contains information on the following subjects: → Warning and indicator lamps → Pedals → Manual gearbox: selecting a gear → Automatic gea ...

Pedals

Fig. 132 Pedals in vehicles with a manual gearbox: ① accelerator, ② brake pedal, ③ clutch pedal Fig. 133 Pedals in vehicles with an automatic gearbox: ① accelerator, ② brake pedal Fi ...

Other materials:

Checklist for evaluating running gear on accident vehicles
Damage to running gear may go unnoticed during repairs to load-bearing and suspension parts of accident vehicles. Under certain circumstances, this undiscovered damage could lead to serious consequential damage during later vehicle operation. Therefore, ...

Removing and installing rear tunnel cross-piece
Special tools and workshop equipment required Torque wrench -V.A.G 1331- Removing – Loosen rear underbody panel and press downwards slightly ...

Automatic brake intervention
First read and observe the introductory information and safety warnings The park assist system helps the driver by braking automatically. The automatic braking does not replace the driver's responsibility for the accelerator, brake and clutch . A parking manoeuvre will be interrupte ...