This chapter contains information on the following subjects:
→ Warning and indicator lamps
→ Pedals→ Manual gearbox: selecting a gear
→ Automatic gearbox: selecting a gear→ Changing gear using Tiptronic
→ Driving with an automatic gearbox→ Fault in the function of the automatic gearbox
→ Gear-change indicatorNotes in this chapter concerning the automatic gearbox are applicable both for the automatic gearbox and the dual clutch gearbox DSG®.
The following will occur if reverse gear is selected and the ignition is switched on:
Additional information and warnings:

WARNING

WARNING

NOTICE
Changing gear
Warning and indicator lampsBleeding hydraulic system following standard procedure
Note
Bleeding the hydraulic system using brake filling and
bleeding equipment -VAS 5234- is described.
A pre-pressure of 2 bar is required for bleeding the ABS
hydraulic unit -N55-.
Specia ...
Notes on releasing and dismantling contact housings
Note
Observe the general notes on repairs to the vehicle
electrical system
→ Chapter.
To release, always use the correct release tools. Under no
circumstances should the contacts be pulled out of the ...
Checking fuel pressure sender -G247-
Special tools and workshop equipment
required
Vehicle diagnostic tester
Pressure sensor tester -VAS 6394-
Test instrument adapter/DSO (3-pin) -VA ...