This chapter contains information on the following subjects:
→ Contents of the breakdown set
→ Preparation→ Sealing and inflating tyres
→ Test after driving for 10 minutesYou can use the breakdown set (tyre mobility set) to safely seal any tyre damage caused by foreign bodies or punctures (up to 4 mm in diameter). Do not remove foreign objects (e.g. screws or nails) from the tyre!
Once the sealant has been added to the tyre, the tyre pressure must be checked again after approximately 10 minutes of driving.
Seek expert assistance if more than one vehicle tyre is damaged. The breakdown set is only designed for filling one tyre.
Only use the breakdown set if the car is parked in a safe place, you are familiar with the required actions and safety procedures, and you have access to the correct breakdown set. Seek expert assistance if this is not the case.
The tyre sealant must not be used:
Additional information and warnings:

WARNING

WARNING
Dispose of used or out-of-date sealant in accordance with legal requirements.
You can get a new tyre filler bottle from a Volkswagen dealership.
Observe the separate instructions from the manufacturer of the breakdown set.
Breakdown set
Contents of the breakdown setRemoving and installing cover cap, without lock cylinder
Note
The cover cap is installed when no lock cylinder is fitted.
Removing
Special tools and workshop equipment
required
Assem ...
Removing and installing rain and light sensor, vehicles with front camera
for driver assist systems
Note
The rain and light sensor has a silicon layer (coupling pad)
which forms the contact surface to the windscreen.
The rain and light sensor has been designed so that it can
be used again. A prerequisite for re-use ...
HS spot thinner
Designation:
HS spot thinner -LVM 006 000 A2-
Issued 06.2013
Product description
HS spot thinner -LVM 006 000 A2- is a special drying
accelerator for small repairs with 2-pac ...