Volkswagen Golf Service & Repair Manual: Switching off auxiliary and supplementary heater
If the button instant heat button has been pressed, or after
the preset operating time has expired or the coolant has reached
a temperature of 88° C, the combustion is ended and the run-on
mode begins. The circulation pump -V55- and the combustion air
blower -V6-, however, continue to run to cool down the heater
(run-on mode) and are switched off automatically. |
Note
The run-on period of the circulation pump -V55- and the
combustion air blower -V6- depends on the operating mode in
which the auxiliary and supplementary heater was switched off.
|
The run-on period is approx. 3 minutes. |
Depending on the control unit software version, slight
deviations in the specified run-on values are possible. |
|
|
|
Switching on auxiliary heater mode in vehicles with manual
air conditioning:
–
Press instant heating button-1-.
...
Other materials:
Removing and installing wheel bearing unit, torsion beam axle
Special tools and workshop equipment required
Fitting sleeve -3241/4-
Hub grease cap puller -VW 637/2-
Torque wrench -V.A.G 1332-
Tool insert -T10162 A-
Torque wrench -V.A.G 1410-
...
Stopping the engine
First read and observe the introductory information
and safety warnings
The actions should only be carried out in the specified order.
Step
Vehicles without Keyless Access
Vehicles with Keyless Access
1.
The vehicle must b ...
Assembly overview - rear window wiper system
1 -
Cap
2 -
Nut
Specified torque: 12 Nm
3 -
Wiper arm with joint-free wiper
Removing and installing
→ Chapter
Adjusting park position
→ Ch ...
© 2016-2024 Copyright www.vwgolf.org
![](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAEALAAAAAABAAEAAAIBTAA7)