Volkswagen Golf Service & Repair Manual: Vehicle level senders
- Assembly overview - front vehicle level senders
- Assembly overview - rear vehicle level sender, torsion beam axle
- Assembly overview - rear vehicle level senders, multi-link suspension, front-wheel drive
- Assembly overview - rear vehicle level senders, multi-link suspension, four-wheel drive
- Removing and installing front vehicle level senders -G78-/-G289-
- Removing and installing rear left vehicle level sender -G76-, torsion beam axle
- Removing and installing rear left vehicle level sender -G76-, multi-link suspension, front-wheel drive
- Removing and installing rear left vehicle level sender -G76-, multi-link suspension, four-wheel drive
Removing and installing rear body acceleration sender -G343-
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Re ...
Assembly overview - front vehicle level senders
Note
The front left/right vehicle level sender -G78/G289- is only
available as a replacement part complete with coupling rod and upper and
lower retaining plates.
...
Other materials:
Identification of Denso heater and air conditioning unit
Note
Pay attention to correct assignment when replacing
components. The combination of different makes of component is
not permitted
→ Electronic Parts Catalogue.
–
Remove left centre console trim ...
Removing and installing front treble loudspeakers -R20-/-R22-
Front left treble loudspeakers -R20-/front right treble
loudspeakers -R22- are located in A-pillar trim.
Note
If the treble loudspeaker needs to be renewed, the A-pillar
trim will also need renewing.
...
Removing and installing air recirculation flap control motor -V113-, RHD
vehicles
Heater and air conditioning system with electric/manual
controls
Special tools and workshop equipment
required
Vehicle diagnostic tester
Note
The control motor has end stops wi ...
