First read and observe the introductory information
and safety warnings
The vehicle has been manufactured specifically for a particular country and complies with the registration regulations that applied in that country at the time of vehicle production.
If the vehicle is going to be sold in another country or used in another country for an extended period, the legal requirements applicable in that country must be observed.
In some cases, certain equipment will have to be fitted or removed and functions deactivated. The scope and type of service available may also be affected. This is particularly important if the vehicle is driven in another climate region for a long period of time.
Because different frequency bands are used in different countries, the factory-fitted radio or navigation system may not work in other countries.

NOTICE
Information stickers and plates
Radio reception and aerialsRemoving and installing control unit for electronic steering column lock
-J764-
Note
When renewing control unit, select
Renewal function for respective control unit in “Guided
fault finding” or “Guided functions” using → Vehicle
diagnostic tester.
Special tools and workshop equipmen ...
Checking operation of belt buckle
Checking belt buckle
–
Push latch plate into belt buckle until it engages audibly.
Check whether locking mechanism is properly engaged by pulling
firmly on belt webbing.
If latch plate fails ev ...
Removing and installing electronically controlled damping control unit
-J250-, saloon
Special tools and workshop equipment
required
Vehicle diagnostic tester
Removing
Location: electronically controlled damping control unit
-J250- is installed behind left luggage compartment s ...