Volkswagen Golf Owners Manual: Radio reception and aerials

Volkswagen Golf Owners Manual / Cleaning and maintenance / Vehicle care and maintenance / Consumer information / Radio reception and aerials

First read and observe the introductory information and safety warnings

For factory-fitted radio and navigation devices, the aerial for radio reception can be installed in various locations in the vehicle:

On the inside of the rear window, together with the rear window heating.

On the inside of the rear side windows.

On the inside of the windscreen.

On the roof of the vehicle.

Aerials on the interior of the windows can be identified by thin wires.

NOTICE

Aerials located on the inside of the windows can be damaged by corrosive or acidic detergents, any other chemicals or if hard objects chafe against the window. Never apply stickers over the window aerials and never clean the aerials with corrosive or acidic detergents or any other chemicals.

NOTICE

When retrofitting a radio or a navigation system ensure that the vehicle's standard integral aerial amplifier is compatible with the radio or navigation system or else use an additional antenna adapter. Otherwise the aerial amplifier could be subjected to overvoltage damage.

Interference of AM radio reception could occur if electrical devices are used in the vicinity of the aerials in the windows.

Using the vehicle in other countries and continents

First read and observe the introductory information and safety warnings The vehicle has been manufactured specifically for a particular country and complies with the registration regulations tha ...

Component protection

First read and observe the introductory information and safety warnings Some electronic components and control units are fitted with component protection as standard, e.g the radio or navigation ...

Other materials:

Introduction
This chapter contains information on the following subjects: → Indicator lamp → Information on changing bulbs → Changing bulbs in the halogen headlights → Changing bulbs in xenon headlights → Changing bulbs in the front bumper → Changing bulbs ...

Removing and installing washer pump, »R«
Special tools and workshop equipment required Drip tray Removing – Remove washer fluid reservoir → Chapter. ...

Removing and installing ambient temperature sensor -G17
Note The ambient temperature sensor -G17- is used for determining the outside temperature and as a switch-on condition of the auxiliary and supplementary heater via CAN bus. – Removing and installing ambient temper ...