Volkswagen Golf Service & Repair Manual: Removing and installing bracket for parking aid control unit -J446-/park assist steering control unit -J791-, LHD vehicles

Volkswagen Golf Service & Repair Manual / Electrical system / Wiring / Control units / Removing and installing bracket for parking aid control unit -J446-/park assist steering control unit -J791-, LHD vehicles

Special tools and workshop equipment required

Feeler gauge

Removing

–	If fitted, remove parking aid control unit/park assist steering control unit → Chapter.

–	To release the fasteners, insert a feeler gauge (0.9 mm) -2- behind the opening -arrow-, as shown in illustration.

–	Remove bracket -1- downwards from bracket for onboard supply control unit -3-.

Installing

Installation is carried out in the reverse sequence.

Removing and installing bracket for parking aid control unit -J446-/park assist steering control unit -J791-, LHD vehicles

Renewing bracket for onboard supply control unit -J519-, LHD vehicles

Removing – Remove bracket for onboard supply control unit -J519- → Chapter. – Remove on ...

Removing and installing engine sound generator control unit -J943-, vehicles with active sound, Golf GTD

Removing – Remove C-pillar trim → General body repairs, interior; Rep. gr.70. ...

Other materials:

Removing and installing control unit for daytime running light and side light -J860-/-J861-
WARNING Risk of death due to high voltage! Risk of injury and environmental pollution! Observe operation and safety notes for gas discharge bulbs → Chapte ...

Overview of fitting locations - front control motors, LHD vehicles
1 - Temperature flap control motor -V68- Checking: with vehicle diagnostic tester Removing and installing → Chapter Renewing: initiate basic setting using vehicle diagnostic tester. 2 -&nbs ...

Removing and installing track rod
Special tools and workshop equipment required Torque wrench -V.A.G 1332- Open-end insert, 38 mm -V.A.G 1923- Ball joint puller -T10187- Locking pliers for Phaeton steering rack -VAS 6199- ...