VW Golf manuals

Volkswagen Golf Owners Manual: Starting the engine with jump leads

Volkswagen Golf Owners Manual / If and when / Practical tips / Starting the engine with jump leads

Changing the bulb in the number plate light
Fig. 241 In the rear bumper: number plate light Fig. 242 Number plate light: removing the bulb holder First read and observe the introductory information and safety warnings ...

Introduction
This chapter contains information on the following subjects:  → Jump lead connection point (earth connection)  → How to start the engine using jump leads If the engine fails to start ...

Other materials:

Assembly overview - poly V-belt drive, vehicles with air conditioner compressor
1 -  Poly V-belt Check for wear Before removing, mark direction of rotation with chalk or felt-tipped pen. Do not kink The length of the poly V-belt must be determined according to the → E ...

Seat belt verification
Removing and installing seat occupied sensor, front passenger side -G128-   Note The seat occupied sensor is only installed in the front passenger seat. Removing   WARNING ...

Removing automatic distance control unit from and installing on retaining plate, variant 2
  Note If the automatic distance control unit -J428- is renewed, start the respective function → Vehicle diagnostic tester. Special tools and workshop equipment required     ...

© 2016-2025 Copyright www.vwgolf.org