Volkswagen Golf Owners Manual: Service and disposal of belt tensioners

Volkswagen Golf Owners Manual / Before the journey / Sitting correctly and safely / Seat belts / Service and disposal of belt tensioners

First read and observe the introductory information and safety warnings

Seat belts may become damaged during any work on the belt tensioners or while removing or refitting any vehicle parts in conjunction with any other repair work. This damage will not always be noticeable. The consequence may be that the belt tensioners could function incorrectly, or not function at all, in the event of an accident.

Regulations must be observed to ensure that the effectiveness of the belt tensioner is not reduced and that removed parts do not cause any injuries or environmental pollution. Qualified workshops are familiar with these requirements.

WARNING

The risk of severe or fatal injuries may be increased if the seat belts, automatic belt retractors and belt tensioners are not used correctly, or if they are repaired by a non-professional. As a result, the belt tensioners may not be triggered when they should, or they may be triggered unexpectedly.

Any repairs, adjustments or removal and refitting of parts in the belt tensioners or seat belts should always be carried out by a qualified workshop and never by yourself .

Belt tensioners and automatic belt retractors cannot be repaired. They must be replaced.

The airbag modules and belt tensioners may contain perchlorate. Please comply with legislation regarding disposal.

Automatic belt retractor, belt tensioner, belt tension limiter

First read and observe the introductory information and safety warnings The seat belts in the vehicle are part of the vehicle safety concept and include the following important functions: ...

Airbag system

...

Other materials:

Assembly overview - sill panel moulding
Note The illustration shows the sill panel moulding on the left side. The right-hand side is similar (mirror image of left-hand side). I: sill panel moulding, 4-door model II: sill panel moulding, 2-door model 1 - Sill ...

Removing and installing wheel bearing housing
Special tools and workshop equipment required Ball joint puller -3287A- Spreader -3424- Ball joint puller -T10187- Torque wrench -V.A.G 1332- Engine and gearbox jack -V.A.G 1383 A- Angl ...

Introduction
This chapter contains information on the following subjects: → Jump lead connection point (earth connection) → How to start the engine using jump leads If the engine fails to start because the vehicle battery is flat, the flat battery can be connected to the battery of another ...