Volkswagen Golf Owners Manual: Securing child seats with the top tether

Volkswagen Golf Owners Manual / Before the journey / Sitting correctly and safely / Child seats (accessories) / Securing child seats with the top tether

Fig. 80 Retaining rings for the top tether on the back of the rear bench seat

First read and observe the introductory information and safety warnings

Observe the instructions provided by the child seat manufacturer when fitting or removing the child seat .

Release the seat backrest and fold the backrest forwards slightly .

Remove the head restraint located behind the child seat and stow it securely in the vehicle .

Guide the top tether of the child seat to the rear between the backrest and luggage compartment cover into the luggage compartment.

Fold back the seat backrest and push it firmly to lock it in place.

Attach the child seat to the lower anchoring points .

In the luggage compartment, hook the top tether into the retaining ring labelled Top Tether behind the corresponding seat .

Stretch the belt.

Reinstall the head restraints after the child seat has been removed .

WARNING

Child seats attached using the lower anchoring points and top tether must be fitted according to the instructions from the manufacturer. Failure to do so could lead to severe injuries.

Never attach more than one top tether from a child seat to one retaining ring in the luggage compartment.

Only use the specially fitted retaining rings when attaching the top tether.

Never fasten the top tether to one of the fastening rings.

Securing child seats using lower anchoring points (ISOFIX, LATCH)

Fig. 78 On vehicle seat: different markings identifying the lower anchoring points for child seats Fig. 79 On the vehicle seat: protective caps for the inner anchoring point First read and obs ...

Lights and vision

...

Other materials:

Assembly overview - brake caliper FS III
When carrying out repairs, install all parts supplied in repair kit. Use only methylated spirits for cleaning the brake. Apply thin coat of lithium grease -G 052 150 A2- to brake cylinder, piston and seal. 1 - Dust cap ...

Corrosion protection for body components, add-on components and welded components
Attachments Wings, doors, covers and flaps must be coated completely on the inside as well. One wet-in-wet spray pass is adequate for this. Before installing, add-on parts must be sealed with cav ...

Removing and installing boot
Special tools and workshop equipment required Hose clip pliers -V.A.G 1275- Torque wrench -V.A.G 1332- Tool insert 24 mm -V.A.G 1332/11- Locking pliers for Phaeton steering rack -VAS 6199- ...