VW Golf manuals

Volkswagen Golf Service & Repair Manual: Safety precautions when working on vehicles with Start/Stop system

Volkswagen Golf Service & Repair Manual / Running gear, axles, steering / Technical data / Notes on safety / Safety precautions when working on vehicles with Start/Stop system

  WARNING
All bolts and nuts must be fully tightened according to specifications before the vehicle is driven on public roads.
  WARNING
There is a risk of an accident through an automatic engine start on vehicles with Start/Stop system.
On vehicles with an active Start/Stop system the engine may start automatically.
Therefore it is essential to ensure that the Start/Stop system has been deactivated when working on the vehicle (switch off ignition, then switch on again as required).
   
Notes on safety
...

Safety precautions when working on subframe
It is not permitted to carry out welding and straightening operations on load-bearing or wheel-guiding suspension components. Always rene ...

Other materials:

Renewing bonded rubber bush for wheel bearing housing, front-wheel drive
Special tools and workshop equipment required Assembly tool -3301- Assembly tool -3346- Assembly tool -3350- Assembly tool -T10356- Carrier -3390- Torque wrench -V.A.G 1332- &nb ...

Checking systems with a restrictor and reservoir and air conditioner compressor regulating valve -N280- (with externally regulated air conditioner compressor)
  Note Connecting air conditioner service station → Chapter. Observe the test prerequisites → Chapter. –  Raise engine speed to 2,000 rpm. ...

Removing and installing reversing camera -R189-
Reversing camera and swivel motor are each installed in individual housings together in swivel badge of rear lid. To remove camera housing, remove first both components together with swivel badge from rear lid. Afterwards, camera housing together with sw ...

© 2016-2026 Copyright www.vwgolf.org