Volkswagen Golf Service & Repair Manual: Safety precautions when working on subframe

Volkswagen Golf Service & Repair Manual / Running gear, axles, steering / Technical data / Notes on safety / Safety precautions when working on subframe

It is not permitted to carry out welding and straightening operations on load-bearing or wheel-guiding suspension components.

Always renew corroded nuts and bolts.

Bonded rubber bushes can be twisted only to a limited extent. Therefore, tighten the bolted connections of components with bonded rubber bushes only when the wheel bearing housing has been raised (unladen state) → Chapter.

Safety precautions when working on vehicles with Start/Stop system

WARNING All bolts and nuts must be fully tightened according to specifications before the vehicle is driven on public ...

Repair instructions

...

Other materials:

Overview of fitting locations- sound system, vehicles with Dynaudio sound system
On vehicles equipped with a Dynaudio sound system, high-quality Dynaudio loudspeakers can be found at standard fitting locations. The Dynaudio sound system can be identified by the lettering Dynaudio on front treble loudspeaker trims. A subwoofer install ...

Removing and installing protective cap
Special tools and workshop equipment required Removal wedge -3409- Thrust piece -T10502- for rear brake FNc-M38 (15”) ...

Air conditioning system compressor with magnetic clutch
The air conditioner compressor is driven by a V-belt from the engine. An electromagnetic clutch is fitted to the air conditioner compressor. When the air conditioning system is switched on, it transmits the mechanical drive between the V ...