VW Golf manuals

Volkswagen Golf Service & Repair Manual: Overview of fitting locations- sound system, vehicles with Dynaudio sound system

Volkswagen Golf Service & Repair Manual / Communication / Infotainment / Sound system / Overview of fitting locations- sound system, vehicles with Dynaudio sound system

On vehicles equipped with a Dynaudio sound system, high-quality Dynaudio loudspeakers can be found at standard fitting locations. The Dynaudio sound system can be identified by the lettering Dynaudio on front treble loudspeaker trims. A subwoofer installed in the spare wheel well in luggage compartment is responsible for handling low bass sounds. An MIB light amplifier is used as digital sound package control unit.
   

Overview of fitting locations- sound system, vehicles with Dynaudio sound system

1 -  Front treble loudspeaker
Front left treble loudspeaker -R20-
Front right treble loudspeaker -R22-
In A-pillar trims
Removing and installing → Chapter.
2 -  Digital sound package control unit -J525-
Under left front seat
In luggage compartment on left under floor, eGolf
Removing and installing → Chapter
3 -  Rear treble speaker
Treble loudspeaker, rear left -R14-
Treble loudspeaker, rear right -R16-
2-door: in side trim panels
4-door: in door trim panels
Removing and installing → Chapter
4 -  Subwoofer -R211-
In spare wheel well
Removing and installing → Chapter
5 -  Rear bass speaker
Bass loudspeaker, rear left -R15-
Bass loudspeaker, rear right -R17-
2-door: in sidewalls
4-door: in rear doors
Removing and installing → Chapter
6 -  Front bass loudspeaker
Bass loudspeaker, front left -R21-
Bass loudspeaker, front right -R23-
In front doors
Removing and installing → Chapter
Overview of fitting locations- sound system, vehicles with Volkswagen sound system
1 -  Front treble loudspeaker Front left treble loudspeaker -R20- Front right treble loudspeaker -R22- In A-pillar trims ...

Digital sound package control unit -J525-, vehicles with Volkswagen sound system
Special tools and workshop equipment required     Torque wrench -V.A.G 1783-   ...

Other materials:

Removing and installing valve, metal valve
Special tools and workshop equipment required     Torque wrench -V.A.G 1410- Carry out the following work: Removing –  R ...

Removing and installing evaporator temperature sensor -G308-, LHD vehicles
Special tools and workshop equipment required     Removal wedge -3409-   Note Only vehicles with air conditioning system; on vehicles with heater, opening in heater ...

Running-in
First read and observe the introductory information and safety warnings Please follow the regulations concerning running-in new parts. Running in a new engine Any new engine has to be run in during the first 1,500 kilometres. During its first few hours of running, the internal friction in ...

© 2016-2026 Copyright www.vwgolf.org