Connecting brake pedal to brake servo
–
Hold ball head of push rod in front of mounting and push
brake pedal in direction of brake servo, so that the ball head
clicks into place.
–
Check engagement by pulling briefly on brake pedal.
...
Assembly overview - skid plate
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
1 -
Underride guard
Removing
–
Remove bolts -2-,
-3- and -4-.
–
Pull out noise ...
Wiring open circuit with one repair position
Repair position with single crimp connector
–
Place the wire to be repaired to one side (about 20 cm
either side of the repair position).
–
If necessary, unbind the wir ...