Volkswagen Golf Service & Repair Manual: Removing and installing rear treble loudspeakers -R14-/-R16-, 4-door

Volkswagen Golf Service & Repair Manual / Communication / Infotainment / Sound system / Removing and installing rear treble loudspeakers -R14-/-R16-, 4-door

Rear left treble loudspeakers -R14-/rear right treble loudspeakers -R16- are located in rear door trim panels.

Note

If the treble loudspeaker must be renewed, the loudspeaker grille must also be renewed.

Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way.

Removing

–	Switch off ignition and all electrical consumers, and remove ignition key.

–	Remove rear door trim → General body repairs, interior; Rep. gr.70.

–	Detach treble loudspeaker with loudspeaker grille from door trim using workshop tools.

Installing

–	Insert treble loudspeaker with loudspeaker grille in door trim.

–	Heat pins with workshop equipment so that loudspeaker grille is seated securely and flush in side trim panel.

–	Connect connector.

–	Install door trim → General body repairs, interior; Rep. gr.70.

Removing and installing rear treble loudspeakers -R14-/-R16-, 2-door

Rear left treble loudspeakers -R14-/rear right treble loudspeakers -R16- are located in rear side trim panels. Note If the trebl ...

Removing and installing front bass loudspeakers -R21-/-R23

The front left bass loudspeaker -R21- and the front right bass loudspeaker -R23- are located in the front doors (bottom). Note Removal ...

Other materials:

General information
Repair instructions for repair work on ABS The ABS brake system is divided diagonally. The servo-assistance is effected pneumatically by the vacuum brake servo unit. Vehicles with ABS are not fitted with a mechanical bra ...

Vehicles with multilink suspension
1 - Rubber mounting Renew if damaged 2 - Bolt 20 Nm 3 - Mounting Renew if damaged 4 - Centre silencer Combined in one u ...

Assembly overview - suspension, multi-link suspension, four-wheel drive
1 - Drive shaft 2 - Bolt Renew after removing 70 Nm +90° 3 - Wheel bearing housing Removing and installing → Chapter 4 - ...