Volkswagen Golf Service & Repair Manual: Removing and installing rear treble loudspeakers -R14-/-R16-, 2-door

Volkswagen Golf Service & Repair Manual / Communication / Infotainment / Sound system / Removing and installing rear treble loudspeakers -R14-/-R16-, 2-door

Rear left treble loudspeakers -R14-/rear right treble loudspeakers -R16- are located in rear side trim panels.

Note

If the treble loudspeaker must be renewed, the loudspeaker grille must also be renewed.

Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way.

Removing

–	Switch off ignition and all electrical consumers, and remove ignition key.

–	Remove side trim panel → General body repairs, interior; Rep. gr.70.

–	Disconnect connector.

–	Detach treble loudspeaker with loudspeaker grille from side trim panel using workshop tools.

Installing

–	Insert treble loudspeaker with loudspeaker grille in door trim.

–	Heat pins with workshop equipment so that loudspeaker grille is seated securely and flush in side trim panel.

–	Connect connector.

–	Install side trim panel → General body repairs, interior; Rep. gr.70.

Removing and installing front treble loudspeakers -R20-/-R22-

Front left treble loudspeakers -R20-/front right treble loudspeakers -R22- are located in A-pillar trim. Note If the treble loud ...

Removing and installing rear treble loudspeakers -R14-/-R16-, 4-door

Rear left treble loudspeakers -R14-/rear right treble loudspeakers -R16- are located in rear door trim panels. Note If the trebl ...

Other materials:

Washing the vehicle
First read and observe the introductory information and safety warnings The longer substances such as insects, bird droppings, resinous tree sap, road dirt, industrial deposits, tar, soot or road salt and other corrosive materials remain on the vehicle, the more damage they do to the paintwo ...

Adjusting spray jets
Caution Danger of causing damage. Do not use any objects for cleaning spray jets! Note In case of uneven spray field due to impurities in th ...

Balancing wheel, conditions
Before you start balancing the wheels, the following requirements must be met. Tyre pressure must be OK. Tread must not be worn on one side. Tread depth should be at least 4 mm. T ...