Volkswagen Golf Service & Repair Manual: Removing and installing rear bass loudspeakers -R15-/-R17-, 4-door

Volkswagen Golf Service & Repair Manual / Communication / Infotainment / Sound system / Removing and installing rear bass loudspeakers -R15-/-R17-, 4-door

Rear left bass loudspeakers -R15-/rear right bass loudspeakers -R17- are located in rear doors (bottom).

Note

Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way.

Removing

–	Switch off ignition and all electrical consumers, and remove ignition key.

–	Remove rear door trim → General body repairs, interior; Rep. gr.70.

–	Release locking mechanism of connector on rear left bass loudspeaker -R15- in direction of arrow.

–	Pull connector -1- out.

Removing and installing rear bass loudspeakers -R15-/-R17-, 4-doorN91-11239

–	Drill out rivet -1- with a suitable drill bit.

–	Remove front left bass loudspeaker -R15-.

Caution

It is essential that all swarf be removed from the door because otherwise corrosion damage will occur.

Immediately rectify any paintwork damage caused when drilling out the rivets.

Installing

Install in the reverse order of removal. When doing this, note the following:

Note

When installing loudspeaker, secure it with special blind rivets (note part number).

Removing and installing rear bass loudspeakers -R15-/-R17-, 4-door

Removing and installing rear bass loudspeakers -R15-/-R17-, 2-door

Rear left bass loudspeakers -R15-/rear right bass loudspeakers -R17- are located in side panel. Note Removal and installation are desc ...

Removing and installing subwoofer -R211-

The subwoofer -R211- is located in the spare wheel well. Removing – Switch off ignition and all electrical consumers, ...

Other materials:

Assembly overview - control unit and hydraulic unit, LHD vehicles
1 - Brake line From primary piston circuit of brake master cylinder to hydraulic unit. Identification: Ш 6 mm and flare nut with thread M 12 x 1 14 Nm 2 - Brake line Fr ...

Assembly overview - pistons and conrods
1 - Bolts Renew Oil threads and contact surface 30 Nm + 90° 2 - Conrod bearing cap The conrod bearing cap only fits in one position and only on the appropriat ...

Permanent underbody protection -D 314 D38 M2-, light
Designation: Permanent underbody protection -D 314 D38 M2-, light Issued 02.2010 Product description Permanent underbody protection -D 314 D38 M2- is a light, transparent, no ...