Volkswagen Golf Service & Repair Manual: Removing and installing parking lock
| – |
Remove cover for parking lock -1-
→ Chapter. |
|
|
|
| – |
Remove bolts -2- and pull
parking lock -1- off dowel sleeves
-arrows-. |
| If parking lock cannot be removed by hand: |
| – |
Apply multi-purpose tool -VW 771- with extractor tool -VW
771/37- behind parking lock and remove parking lock by pulling
on alternate sides. |
| – |
Always renew bolts -2-. |
| – |
Fit parking lock -1- onto dowel
sleeves -arrows-. |
| – |
Screw in new bolts -2-,
specified torque 20 Nm + 90° further. |
| – |
Install cover for parking lock -1-
→ Chapter. |
|
|
|
Special tools and workshop equipment
required
Removal lever -80 - 200-
Removing
...
Other materials:
Run-flat tyres, PAX, inflating tyre
Observe the following important points when inflating the
tyre:
–
Only inflate after fitting the tyre with valve core
installed. Check whether the beads have properly seated at 1
bar.
–
...
Assembly overview - drive shaft
1 -
Outer constant velocity joint
Renew only as complete unit
Removing
→ Fig..
Installing: drive onto shaft to stop using plastic hammer
Distribute grease evenly in joint
Ch ...
Removing and installing voltage regulator, manufacturer: Bosch
Special tools and workshop equipment
required
Offset screwdriver for slotted-head screws -VAS 6416-
Torque screwdriver -V.A.G 16 ...
© 2016-2025 Copyright www.vwgolf.org
Removing and installing cover for parking lock