Volkswagen Golf Service & Repair Manual: Removing and installing door arrester
| Special tools and workshop equipment
required |
|
|
|
 Note
| Removal and installation are only described for the left
door retaining strap. The right side is similar. |
|
|
Torque wrench -V.A.G 1331- |
| – |
Remove rear door trim
→ General body repairs, interior; Rep. gr.70. |
| – |
Pull off self-adhesive cover. |
| |
For models without loudspeaker pull off self-adhesive cover and
remove door retaining strap through opening for loudspeaker
-arrow c-. |
| |
For models with loudspeaker detach inner door cover
→ Chapter and remove through this opening. |
| – |
Unscrew bolt -2- on B-pillar. |
| – |
Remove screws -3- and remove door
retaining strap -1-. |
| Install in reverse order of removal. |
| |
→ Chapter „Assembly overview - door“ |
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
...
During production, a sealant is applied to the door inner
seals, which are then placed on the door flange and rolled on.
Note
...
Other materials:
Side airbags
Fig. 73 On the left-hand side of the vehicle:
deployment zones of side airbags (variant A). On the side of the front seat: location
and deployment range of the side airbag (variant B)
First read and observe the introductory information
and safety warnings The side airbags are located in th ...
Round connector systems
Note
If necessary, any housing catches in place (secondary
locking mechanisms) must be released or removed prior to
disengaging the contacts using the prescribed tool
→ Chapter.
...
Removing and installing fresh air blower control unit -J126-, RHD vehicles
Removing
–
Remove baffle plate
→ Chapter.
–
Disconnect electrical connectors -1-
and -4-.
–
Remove bolts ...
© 2016-2026 Copyright www.vwgolf.org
Adjusting striker pin
Removing and installing door inner seal