Volkswagen Golf Service & Repair Manual: Removing and installing air intake silencer
| – |
Switch off electrical consumers. |
| – |
Switch off auxiliary and supplementary heater and switch off
ignition. |
| – |
Remove front part of front right wheel housing liner
→ General body repairs, exterior; Rep. gr.66. |
|
|
|
| – |
Squeeze spreader clip -1-
together and twist air intake silencer -2-
out of aluminium pipe. Twist aluminium pipe off connection of
auxiliary and supplementary heater. |
| – |
Install in reverse order. |
| – |
Push spreader clip -1- of air
intake silencer -2- into bracket
until it engages. |
 Note
| The air intake silencer must not touch the auxiliary and
supplementary heater housing. |
| Do not kink or crush aluminium pipe. |
| Wheel housing liner; Removing and installing wheel housing
liner
→ General body repairs, exterior; Rep. gr.66 |
|
|
|
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410- (4…20 Nm)
...
Special tools and workshop equipment
required
Hose clamps, up to 25 mm -3094-
&nbs ...
Other materials:
Removing and installing underbody heat shield
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
Removing
–
Removing centre underbody panel
→ Chapter.
–
Removing front tunnel cross-piec ...
Removing and installing damper element for glove compartment lid
Removing
–
Move glove compartment lid to service position
→ Chapter.
–
Disconnect connector for glove compartment light switch
-E26- on damper element -1-.
– ...
Introduction
This chapter contains information on the following subjects:
→ Folding the backrests on the rear bench seat forwards and backwards
→ Luggage compartment cover
→ Load-through hatch
→ Fastening rings
→ Bag hook
→ Luggage net ...
© 2016-2026 Copyright www.vwgolf.org
Dismantling and assembling auxiliary heater
Removing and installing circulation pump -V55-