Volkswagen Golf Owners Manual: Component protection
First read and observe the introductory information
and safety warnings
Some electronic components and control units are fitted with component protection as standard, e.g the radio or navigation system.
Component protection was developed as a protective mechanism in order to:
- Prevent any factory-fitted parts delivered with a vehicle from functioning fully if they have been installed into other vehicles (e.g. after theft),
- Prevent full function of components outside of the vehicle,
- Allow for legitimate installation or exchange of parts and control units by a professional in the case of service.
| Where | What appears: | Possible solution |
|---|---|---|
| The instrument cluster display | SAFE CP | Proceed to a qualified workshop. |
| Radio or navigation system display | Component protection: Infotainment system currently has limited availability. Switch on the ignition. | Switch on the ignition. If this does not deactivate component protection, seek professional assistance. |
Radio reception and aerials
First read and observe the introductory information
and safety warnings For factory-fitted radio and navigation devices, the
aerial for radio reception can be installed in various locations in t ...
Volkswagen repair information
First read and observe the introductory information
and safety warnings Volkswagen Service information and official Volkswagen
repair information can be purchased from the following addresses:
...
Other materials:
Checking exhaust ventilation for passenger compartment
Note
The stale air escapes via ventilation openings in the
luggage compartment trim.
If the ventilation is to function properly, the exhaust
openings must not be covered.
The ventilation ...
Overview of fitting locations - components inside of front passenger
compartment, LHD vehicles
1 -
Left vent temperature sender -G150-
Only vehicles with Climatronic.
Checking: Use vehicle diagnostic tester in “Guided fault finding”
mode and → Current flow
diagrams, Electrical fault finding and Fitting locatio ...
Removing and installing fuse holder, battery
Removing
–
With ignition switched off, disconnect earth cable from
battery
→ Chapter.
–
Open cover -1-.
–
...
