Adjusting the driving mode to suit your requirements
IntroductionConicity
Conicity is caused by a slight offset of the tread and/or
the belt (amounting to a few tenths of a millimetre) relative to
the geometric centre of the tyre. Taper is not visible and
cannot be measured with equipment available in the workshop.
& ...
Dimensions – lettering on wing, “R”
1 -
Emblem
2 -
Height dimension
5.0 ± 1 mm, from upper edge of lettering to edge of wing
3 -
Horizontal dimension
1.5 ± 1 mm, from outer edge of wing to lettering
...
Removing and installing output module 1 for left LED headlight -A31-/-A27-
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Torque screwdriver -VAS 6494-
N ...