Volkswagen Golf Service & Repair Manual: Perform service test

Volkswagen Golf Service & Repair Manual / Electrical system, general information / Starter- current supply- CC / Checking battery / Perform service test

Note

The print-out may vary depending on software version.

Observe the → operating manual of the battery tester with printerVAS 6161.

WARNING

It is not permissible to test or charge batteries whose colour indicator is light yellow. Do not slave/jump start the vehicle!

Danger of explosion when checking and charging or slave/jump starting.

These batteries must be renewed.

–	Select “Service test” in the menu.

–	Select “On battery terminal” or “On jump-start point”.

–	Select battery type “Normal”, “AGM”, “2*6V” or “Gel”.

–	Select “CCA”, “JIS”, “DIN”, “SAE”, “IEC” or “EN” norm.

–	Select battery value.

–	Measure temperature. Hold temperature sensor about 5 cm above one battery terminal until temperature stabilises.

–	Start test.

–	Print out test log if necessary.

Performing maintenance test

WARNING It is not permissible to test or charge batteries whose colour indicator is light yellow. Do not slave/jum ...

Comments concerning test print out

1 - Check type. 2 - Battery test result 3 - Measured voltage ...

Other materials:

Introduction
This chapter contains information on the following subjects: → Warning and indicator lamps → Information on steering The power steering is not hydraulic. It is an electromechanical system. The advantage of this steering system is that no hydraulic hoses, hydraulic oil, p ...

Masking areas, rear body
Masking areas, rear underbody A - No sealant on threads or contact surfaces. B - Threads waxed D - Threads free of surfacer and top-coat paint (joint surface may be painted) E - ...

Assembly overview - rear vehicle level sender, torsion beam axle
Note The rear left vehicle level sender -G76- is only available as a replacement part complete with coupling rod and upper and lower retaining plates. 1 - Electrical connector 2 - Bolt 5 Nm ...