VW Golf manuals

Volkswagen Golf Service & Repair Manual: O-ring

These O-rings seal the joints between the individual components of the refrigerant circuit.
Use only seals that are resistant to refrigerant R134a and its associated refrigerant oils. This is assured by using genuine replacement parts.
→ Parts catalogue
O-ring:
Never reuse seals!
Check that diameters -a- and -b- are correct.
Before fitting a seal, coat it lightly with refrigerant oil.
  Note
The colour coding of O-rings for R134a refrigerant circuits has been discontinued. Coloured and black O-rings are used.
→ Rep. gr.87
→ Parts catalogue
 

O-ring

Expansion valve
The expansion valve atomises incoming refrigerant and regulates the flow so that, depending on the heat transport, the vapour does not become a gas until it reaches t ...

Pipes and hoses in refrigerant circuit
The mixture of refrigerant oil and refrigerant R134a attacks certain metals (e.g. copper) and alloys and dissolves certain hose materials. Therefore, always use genui ...

Other materials:

Assembly overview - lower suspension link, swivel joint
1 -  Wheel bearing housing Different versions possible. Refer to → Electronic Parts Catalogue “ETKA” Removing and installing → Chapter 2 -  Nut Renew after removin ...

Removing and installing camshaft control valve 1 -N205- and exhaust camshaft control valve 1 -N318-
  Note On engines with codes CMBA, CPVA, CXSA, CZCA and CPVB, only camshaft control valve 1 -N205- is installed. Removing Inlet camshaft control valve 1 -N205- –  Disconnect ele ...

Removing and installing bracket for onboard supply control unit -J519-, LHD vehicles
Removing –  With ignition switched off, disconnect earth cable from battery → Chapter. –  Remove dash panel → General body repairs, interior; Rep. gr.70. ...

© 2016-2026 Copyright www.vwgolf.org