Volkswagen Golf Owners Manual: Locking the front passenger door and rear doors manually

Volkswagen Golf Owners Manual / If and when / Practical tips / Manual opening and closing / Locking the front passenger door and rear doors manually

Fig. 210 In the end face of the right-hand door: manual lock covered by a rubber seal

Fig. 211 Manually locking the vehicle with the vehicle key

First read and observe the introductory information and safety warnings

The front passenger door and the rear doors can be locked manually. This does not activate the anti-theft alarm.

Open the door.

Remove the rubber seal from the end face of the door. The seal is marked by a lock symbol .

Fold the key bit out of the vehicle key.

Insert the key bit into the slot behind the opening and turn clockwise (arrow) on the right door and anticlockwise on the left door.

Put the rubber seal back in place and close the door fully.

Ensure that the door is locked.

If required, repeat the process for the other doors.

The vehicle should be checked by a qualified workshop as soon as possible.

The doors can be unlocked and opened from the inside by pulling the door release handle. You may have to pull the door release lever twice .

Locking and unlocking the driver door manually

Fig. 209 Door handle on the driver door: covered lock cylinder First read and observe the introductory information and safety warningsIf locked manually, all doors are locked. If unlocked manu ...

Unlocking the tailgate manually

Fig. 212 In the tailgate: opening the warning triangle holder Fig. 213 In the luggage compartment: unlocking the tailgate First read and observe the introductory information and safety warni ...

Other materials:

Removing and installing pistons
Special tools and workshop equipment required Drift -VW 222 A- Piston ring clamp, commercially available Removing – ...

Testing for leaks
Special tools and workshop equipment required Tester for brake pressure regulator -V.A.G 1310 A- Adapter M10 -V.A.G 1310/6- Test prerequisites: ...

Assembly overview - suspension strut, shock absorber, spring, torsion beam axle
1 - Bolt Renew after removing 50 Nm +45° 2 - Shock absorber Removing and installing → Chapter Defective shock absorbers must always be degassed and drai ...