Volkswagen Golf Owners Manual: Introduction

Volkswagen Golf Owners Manual / If and when / Practical tips / Hubcaps / Introduction

This chapter contains information on the following subjects:

→ Centre cover

→ Wheel cover

→ Wheel bolt caps

Additional information and warnings:

Cleaning and caring for the vehicle exterior

Vehicle toolkit

Changing a wheel

Breakdown set

WARNING

Using unsuitable hubcaps, or fitting them incorrectly, can cause accidents and serious injuries.

Incorrectly fitted hubcaps can become loose while the vehicle is in motion and endanger other road users.

Do not use damaged hubcaps.

Always ensure that the airflow to cool the brakes is not restricted or reduced. This also applies if hubcaps are retrofitted. If the airflow is not sufficient, the braking distance could increase significantly.

NOTICE

Remove the hubcaps carefully and fit them again properly so as to avoid damage to the vehicle.

Centre cover

Fig. 218 Removing the centre covers by pulling Fig. 219 Removing the centre covers by turning First read and observe the introductory information and safety warningsThe centre cover can be r ...

Other materials:

Schematic diagram - coolant hoses, Golf GTE
Note Currently, only the auxiliary heater function is available. At the moment the auxiliary heater is not intended to be operated as a supplementary heater. In vehicles with a high-voltage system, the high-voltage heater (PTC) -Z115- is ...

Maintaining records on refrigerant
Note The laws and regulations listed below are valid in the Federal Republic of Germany. Other or additional laws and regulations may apply in other countries. Sources in other countries may be obtained from the ...

Assembly overview - wheel bearing assembly, torsion beam axle
1 - Dust cap Renew after removing Pressing off and driving in → Chapter A proper seal can be achieved only by installing a new dust cap. 2 - Bolt Renew after remov ...