This chapter contains information on the following subjects:
→ Function
When the toll card system is switched on and functioning, tolls will be charged automatically when driving through a toll booth. The charge will be confirmed by an acoustic signal. The charges will be relayed via a spoken announcement and also shown on the navigation system screen together with the location data.
Additional information and warnings:

WARNING
FunctionRemoving tyres, run-flat tyres, ultra-high-performance tyres
Only trained personnel may perform any assembly work on
run-flat tyres and ultra-high-performance tyres.
If fitted, check tyre pressure sensor using vehicle
diagnostic tester, and renew it as necessary.
Note
...
General
Perform a road test to determine whether a vehicle is
pulling to one side and if so, which side. If the vehicle pulls
to one side
→ Chapter.
When wheel alignment is checked, include the wheel alignment
test results in ty ...
Removing and installing rear axle, multi-link suspension, four-wheel drive
Special tools and workshop equipment required
Torque wrench -V.A.G 1332-
Engine and gearbox jack -V.A.G 1383 A-
Tensioning strap -T10038-
Locating pins -T10486-
Removing subframe with ...