
Fig. 127 In the stowage compartment on the front passenger side: toll card reader
First read and observe the introductory information
and safety warnings Using the toll card system
Switch on the navigation system and insert a suitable ETC card in the toll card reader (arrow).
The device readiness will be confirmed with a long signal tone and displayed with the symbol ETC in the status bar of the navigation system.
Ejecting the toll card
To eject, press the toll card button .
Error message
If a short series of tones is heard when switching on the device, there is a fault, e.g. no ETC card, or the card is faulty. The toll card system cannot be used.
Introduction
While drivingAssembly overview - cylinder block, gearbox end
Note
For assembly work, secure engine to engine and gearbox support
→ Chapter.
1 -
Bolt
Renew
60 Nm + 90°
2 -
Flywheel
Removing and installin ...
Removing and installing entry light in exterior mirror
Special tools and workshop equipment
required
Torque wrench -V.A.G 1783-
Note
Removal and installation are described for the left side.
Removal and insta ...
Removing toothed belt from camshafts, engine code CHPA, CZDA
Special tools and workshop equipment required
Torque wrench -VAS 6583-
Counterhold -T10172- with adapter -T10172/1-
Locking pin -T10340-
Counterhold -T10475-
Special wrench, 30 mm -T10499-
...