First read and observe the introductory information and safety warnings
One-touch opening and closing
One-touch opening and closing makes it possible to fully open and close the windows. The individual buttons do not have to be held down to do this.
For one-touch closing: pull the button for the appropriate window up briefly into the second position.
For one-touch opening: press the button for the appropriate window down briefly into the second position.
Stopping the one-touch function: press or pull the button for the appropriate window again.
Restoring one-touch opening and closing
One-touch opening and closing is deactivated if the vehicle battery has been disconnected or discharged while the windows were not fully closed. The function will have to be reset.
The one-touch function can be restored for individual windows or for several windows at the same time.
Convenience opening and closing
The windows can be opened and closed from outside the vehicle using the vehicle key:
During convenience closing, the windows and the electric panorama sliding/tilting roof close.
A variety of settings related to window operation can be made and adjusted using the button and the and Open and close function buttons .
WARNING
Improper or unsupervised use of the electric windows can cause serious injuries.One-touch opening and closing and the roll-back function will not work if there is a fault in the electric windows. Go to a qualified workshop.
Mechanical controls on the front seat
Fig. 43 Front left-hand seat controls
First read and observe the introductory information
and safety warnings The layout of the controls on the front right-hand seat
is a mirror image of the layout of the controls on the front left-hand seat.
The following section contains a description o ...
High-pressure sender -G65
This high-pressure sender -G65- is fitted in place of the
air conditioning system pressure switch -F129-.
When voltage is applied to the high-pressure sender, it
generates a square wave signal, or data telegram. This signal
changes when ...
Removing and installing Bowden cable for remote release mechanism for seat
backrest
Note
Removal and installation are described for the left vehicle side.
Follow same instructions for the right side as appropriate.
Removing
Bowden cable on backrest end
–
Remove rear seat backrest
→ Chapter.
...