
Fig. 227 The breakdown set
First read and observe the introductory information
and safety warningsThe breakdown set may be located in various places in the vehicle, e.g. in the side stowage area of the luggage compartment or under the floor covering in the variable luggage compartment. It includes the following components :
Valve core extractor
Sticker with the maximum permitted speed
max. 80 km/h or max. 50 mph
Filler hose with plug
Air compressor
Tyre filler hose
Tyre pressure display1)
Air bleed screw2)
ON and OFF switch
12-volt plug
Tyre filler bottle with sealant1)
Spare valve core There is a slot on the lower end of the valve core extractor ① for the valve core. This is required for extracting and fitting the tyre valve. This also applies to the spare valve core ⑪.
1) Could also be integrated in the compressor.
2) This function may be carried out by a button in the compressor instead.
Introduction
PreparationRemoving and installing centre underbody covers
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
Removing
Unclip spreader river -2- and remove
centre underbody panels.
Installing
Installation is carried out in reverse ...
Centre armrest
Fig. 51 Front centre armrest
Fig. 52 Folding down the rear centre armrest
First read and observe the introductory information
and safety warnings Adjusting the front centre armrest
To lift, push the centre armrest up gradually in the direction of arrow
.
To lower, pull the centre ar ...
Introduction
This chapter contains information on the following subjects:
→ Drink holders in the front centre console
→ Drink holders in the rear centre armrest
→ Drink holder in the rear side trim
Bottle holder
Bottle holders are located in the open stowage areas of t ...