Volkswagen Golf Owners Manual: Cleaning and caring for chrome and aluminium trim parts

Volkswagen Golf Owners Manual / Cleaning and maintenance / Vehicle care and maintenance / Caring for and cleaning the vehicle exterior / Cleaning and caring for chrome and aluminium trim parts

First read and observe the introductory information and safety warnings

Use a damp, clean, lint-free and soft cloth to clean the surfaces.

For heavy soiling use a special solvent-free cleaning product.

Polish the chrome and aluminium trim parts using a soft, dry cloth.

NOTICE

To ensure that the chrome and aluminium parts are not damaged:

Do not clean or polish in direct sunlight.

Do not clean or polish in sandy or dusty environments.

Do not use any abrasive care products (e.g. cream cleaners).

Never clean with insect sponges, rough kitchen sponges or similar products.

Do not polish any dirty surfaces.

Do not use solvent-based cleaning products.

Do not use hard wax.

NOTICE

Chrome rims or wheel covers may also have an additional varnish finish and should not be treated using chrome or aluminium cleaning agents or chrome or aluminium polish. Commercially available paint care and cleaning products should be used instead.

Waxing and polishing the vehicle

First read and observe the introductory information and safety warnings Waxing Waxing protects the paintwork. You will need to re-wax the vehicle with a good hard wax if water no longer clearly ...

Cleaning wheels

First read and observe the introductory information and safety warnings Cleaning steel wheels Accumulated brake dust can only be removed with an industrial cleaner. Steel wheels should therefor ...

Other materials:

Setting vehicle to initial position for wheel alignment
If measured values are outside specified tolerances, this may be because the vehicle is inclined. Right-hand drive vehicles or e.g. vehicles with an automatic gearbox may lean to one side slightly. This is due to the ins ...

Assembly overview - oil filter/oil pressure switch
1 - Oil filter Remove and install with oil filter tool -3417-. Before installing, lightly coat seal with clean engine oil. 20 Nm See note → Anchor 2 - Oil pre ...

Assembly overview - rear child seat anchors
1 - ISOFIX child seat anchor Qty. 4 Welded to underbody 2 - Guide For ISOFIX child seat anchor Qty. 4 Removing and installing → Chapter Must be seated firmly on child seat anchor 3 - Li ...