Volkswagen Golf Service & Repair Manual: Blender

Volkswagen Golf Service & Repair Manual / General information, paint / Genuine products / SprayMax System / Blender

Designation:

Blender -LLS MAX 009-

Issued 10.2008

Product description

The blender -LLS MAX 009- is used to achieve homogenous paint transitions in the blending/edge areas between the existing and newly applied paintwork. The raw material basis is a combination of specific resins and solvents.

Properties:

Aerosol formulation made for this specific product for easy application.

Constant atomisation pressure.

Finest aerosol dispersion.

First-class painting results.

Ideal for spot repairs.

Quick and easy to use.

Especially suitable for blending-in of 2-coat paints and single-coat 2-pack paints.

Very good partial dissolving properties.

Easy to polish.

Smooth transitions in blend-in area.

Technical data sheet

Application

Recommended for:

Spot repairs, blending

Suitable substrates:

Apply right after spraying with 2-pack clear coat -LLS MAX 210- or 2-pack top coat on the transition zones in the blend-in area.

The substrate in the fading edge transition zone should be generously matted with an abrasive pad (P2000 to P4000 grade).

Pretreatment:

No special work needed directly before applying the blender.

Application

Note

Protective garments and equipment in accordance with work safety regulations must be worn:

Respirator mask, type A2/P2.

Protective gloves (e.g. latex or nitrile).

Method of application: “spray”.

–	Apply in multiple, light spray passes on the spray-mist edge zone of the 2-pack clear coat or 2-pack top coat until the transition is homogenous.

–	No flash-off time required for 2-pack clear coat or 2-pack top coat.

Note

After any interruption of the spray operation, hold the aerosol upside down, and press the spray button until the valve is empty.

Caution

Protective garments and equipment in accordance with work safety regulations must be worn.

Observe safety information sheets as well as warnings on the label of the spray can.

After fully emptying the spray can, dispose of as recycling material

Data

Blender

Solids content:	4,8 %
Coverage:	Approx. 0.5 mІ per aerosol.
Degree of gloss:	Not applicable
VOC content:	766 g/l ± 306 g per aerosol.

Storage

The guaranteed shelf life is 36 months from date of production. May be used until the date stated on the label at latest if stored in sealed original containers at +20 °C.

Blender

Slow-drying silicone remover -LLS MAX 008

Designation: Slow-drying silicone remover -LLS MAX 008- Issued 10.2008 Product description ...

Adhesion promoter

Designation: Adhesion promoter -LLS MAX 015- for plastics Issued 10.2012 Product description ...

Other materials:

Overview of fitting locations – Start/Stop system
Note Note safety precautions → Chapter. The illustration shows fitting locations for LHD vehicles. Fitting locations for RHD vehicles are similar. 1&nb ...

Brake lines
Repairing brake lines The flanging tool for brake lines -VAS 6056- can be used to flange brake lines with an outer pipe diameter of 5 mm without damaging the coating. In certain cases, this allows sections of brake lines to be renew ...

Front centre armrest
Assembly overview - front centre armrest 1 - Front centre armrest Removing and installing → Chapter Removing and installing front centre armrest Removing and installing front centre armrest &nbs ...