Volkswagen Golf Service & Repair Manual: Assembly overview - water deflector
Note| The right side is shown. The left side is similar. |
| 1 - | Water deflector |
- Removing and installing → Chapter
| 2 - | Retaining strip |
| – | During removal, drill out rivet heads and chop through rivet shanks. |
| 3 - | A-pillar |
| 4 - | Pop rivet |
- Qty. 5
- Insert with pop rivet pliers -VAS 5072-
| 5 - | Clip |
- Position clip in wing hole and press forwards, afterwards turn through 90°
| 6 - | Wing |
- Removing and installing → Chapter
Assembly overview - heat shield
1 -
Underbody heat shield
Removing and installing
→ Chapter
2 -
Retainer
Qty. 6
3 -
Heat shie ...
Other materials:
Test after driving for 10 minutes
First read and observe the introductory information
and safety warningsReconnect the tyre filler hose and check the tyre pressure
on the tyre pressure display ⑥.
1.3 bar (19 psi / 130 kPa) and lower:
Do not drive on! The tyre cannot be sealed adequately with
the breakdown set.
...
Assembly overview - fuel delivery unit/fuel gauge sender, vehicles with
front-wheel drive
1 -
Fuel delivery unit
With fuel system pressurisation pump -G6-.
With integrated fuel filter; cannot be renewed individually.
With integrated pressure limiting valve; cannot be renewed
individually.
C ...
Removing and installing Bowden cable for remote release mechanism for seat
backrest
Note
Removal and installation are described for the left vehicle side.
Follow same instructions for the right side as appropriate.
Removing
Bowden cable on backrest end
–
Remove rear seat backrest
→ Chapter.
...
