Volkswagen Golf Service & Repair Manual: Industrial dirt remover
| Industrial dirt remover -ABS 600 000 10- |
| The industrial dirt remover -ABS 600 000 10- is used for the
removal of surface rust (metal dust) from the vehicle body. The
product is applied undiluted. |
Caution
| The product contains organic and inorganic acids. |
| Be sure to always wear protective gloves and goggles
when working with the product! |
|
 Note
| Before using, read the safety measures and recommendations
in the safety data sheet. |
| Even for products which are not required by law to be
labelled, the usual safety measures for chemical products must
be observed. |
| When using the industrial dirt remover, observe the
following: |
| Neither the temperature of the cleaner nor that of the
vehicle body must exceed 25 °C (do not expose the cleaner nor
the vehicle to direct sunlight). |
| Apply product to clean vehicle body (after car wash) using
brush or sponge. Allow for a reaction time of approx.
10 minutes (the reaction time must not be exceeded to avoid
damage to paintwork or plastic parts). Do not allow the product
to dry on the surface. |
| Rinse off vehicle body with plenty of water, then wash
vehicle. |
| Repeat the cleaning procedure if the vehicle is still not
clean after the cleaner has been applied once. |
|
|
|
| Chemical composition |
Highly effective cleaning
combination of organic and inorganic acids, surfactants and water. |
| Colour |
Transparent/clear, colourless
fluid |
| pH value |
1 |
| Density at 15 °C |
EN ISO 12185 1.076 ± 0.015 g/ml |
| The guaranteed shelf life is 36 months from date of
production. If stored in sealed original container at +15
°C to +30 °C, the product must be processed at the latest by the
end of the date stated on the label. |
|
|
|
Designation:
Cleaner for plastics, antistatic -LVM 001 001 A2-
Note
Information on preparing and applying the c ...
Other materials:
Setting vehicle to initial position for wheel alignment
If measured values are outside specified tolerances, this
may be because the vehicle is inclined.
Right-hand drive vehicles or e.g. vehicles with an automatic
gearbox may lean to one side slightly.
This is due to the ins ...
Removing and installing humidity sender for air conditioning system -G260-
The humidity sender for air conditioning system -G260- and
the light/rain sensor -G397- form one component and are
installed depending on vehicle equipment.
–
Removal and installation procedure is described in
→ E ...
Vapour pressure
In an enclosed container that is not completely full,
refrigerant evaporates as vapour at the surface in a quantity
sufficient to form an equilibrium between vapour and liquid.
This equilibrium develops under pressure and is often called
vapour pressure. ...
© 2016-2026 Copyright www.vwgolf.org
Cleaner for plastics, antistatic
SprayMax System