Volkswagen Golf Service & Repair Manual: Adjusting wiper arm
| Special tools and workshop equipment
required |
|
|
|
| Torque wrench -V.A.G 1331- |
| – |
Remove wiper arm
→ Chapter. |
| – |
Actuate “rear window wipe” function and allow wiper shaft to
move to its end position. |
| – |
Fit wiper arm together with attached wiper blade onto wiper
shaft. |
|
|
|
| – |
Align wiper blade as follows against the rear window: |
 Note
| The dimension given here indicates the distance between the
tip of the wiper blade and the bottom edge of the rear window. |
| Dimension -a - = 33 + 5 mm. |
| – |
Actuate “rear window wipe” function and allow wiper arm to
move to its end position. |
| – |
Check wiper arm adjustment again and correct if necessary. |
| → Chapter „Assembly overview - rear window wiper system“ |
|
|
|
Special tools and workshop equipment
required
Puller -T10369-
...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Removin ...
Other materials:
Silicone remover -LLS MAX 007
Designation:
Silicone remover -LLS MAX 007-
Issued 10.2008
Product description
The silicone remover -LLS MAX 007- is a waterborne cleaning
agent, rich in active ingredients a ...
Coolant specification
First read and observe the introductory information
and safety warnings The cooling system is filled at the factory with a mixture
of specially prepared water and at least 40% coolant additive G 13
(TL-VW 774 J). The coolant additive is dyed purple. This mixture of water and coolant
additi ...
Removing and installing heat exchanger for high-voltage battery
Special tools and workshop equipment
required
Hose clamps, up to 25 mm -3094-
Engine bung set -VAS 6122-
Pliers for spring-type clips -VAS 5024A-
Cooling sy ...
© 2016-2026 Copyright www.vwgolf.org
Removing and installing wiper arm
Removing and installing rear window wiper motor -V12-