First read and observe the introductory information
and safety warnings
Lit up | Possible cause | Solution |
---|---|---|
![]() |
Fault in the alternator. | Proceed to a qualified workshop. The electrical system
should be checked. Switch off all electrical equipment that is not required. The vehicle battery will not be charged by the alternator while the vehicle is in motion. |
Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.
WARNING
NOTICE
Removing and installing bulb for front interior light -W1- with incandescent
bulbs
Special tools and workshop equipment
required
Removal wedge -3409-
Note
The light used for the front interior light -WX1- and the
light front passenger reading ...
Removing and installing ambient temperature sensor -G17
Note
The ambient temperature sensor -G17- is used for determining
the outside temperature and as a switch-on condition of the
auxiliary and supplementary heater via CAN bus.
–
Removing and installing ambient temper ...
Fixing position of subframe, multi-link suspension, four-wheel drive
Special tools and workshop equipment
required
Locating pins -T10096-
Engine and gearbox jack -V.A.G 1383 A-
...