First read and observe the introductory information
and safety warnings
| Lit up | Possible cause | Solution |
|---|---|---|
|
Engine oil level is too low. | Switch off the engine. Check the engine oil level . |
| Flashes | Possible cause | Solution |
|---|---|---|
|
Engine oil pressure is too low. | Do not drive
on! Switch off the engine. Check the engine oil level. – Do not drive on or remain at idling speed if the warning lamp is flashing, even if the engine oil level is correct. This could result in damage to the engine. Seek expert assistance. |
|
Fault in the engine oil system. | Proceed to a qualified workshop. The engine oil sensor should be checked. |

WARNING

NOTICE
Introduction
Engine oil specificationRemoving and installing refrigerant pressure and temperature sender -G395
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331/- (5…50 Nm)
Engine bung set -VAS 6122-
Air condit ...
Removing and installing short centre underbody cover
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
Removing
Unclip spreader river -2- and remove
centre underbody panels.
–
Remove bolt -3-.
Installi ...
Checking holding pressure
Special tools and workshop equipment required
Removal wedge -3409-
Pressure tester -VAS 6550-
Connector cable -VAS 6550/3-3-
Connector cable -VAS 6550/3-4-
Vehicle diagnostic tester
...