VW Golf manuals

Volkswagen Golf Service & Repair Manual: Vibration, conducting a road test before balancing wheels

If a customer brings a vehicle to the workshop complaining about “vibration”, a road test is essential prior to balancing the wheels.
This will give you information about the nature of the vibration.
You will be able to determine the speed range in which vibration occurs.
–  Raise the vehicle on a lifting platform immediately after the road test.
–  Mark installation position on tyre.
   
Tyre position Marked with …
Front left tyre FL
Front right tyre FR
Rear left tyre RL
Rear right tyre RR
 
–  Remove wheels.
–  Balance wheels.
Vibration, causes for vibration
Vibration can have a number of different causes. Vibration can also be caused by tyre wear. Tyre wear caused by driving is not always evenly spread across the entire ...

Vibration, vibration control system
Using the vibration control system -VAS 6230 A- you can perform more functions than just stationary balancing. A special feature of this system is th ...

Other materials:

Removing and installing rain and light sensor, vehicles with front camera for driver assist systems
  Note The rain and light sensor has a silicon layer (coupling pad) which forms the contact surface to the windscreen. The rain and light sensor has been designed so that it can be used again. A prerequisite for re-use ...

Without roller dynamometer for four-wheel drive vehicles
  Note If no test rig is available for four-wheel drive vehicles, the brake test can also be carried out on a standard single-axle roller dynamometer as follows: –  Drive vehicle forwards onto the rollers. ...

Renewing Lambda probe
  Note Do not repair Lambda probe wires, since this can result in malfunctions. If necessary, replace attachment parts, cable ties or marking rings to match the uniform probe to the defective probe as specified. ...

© 2016-2025 Copyright www.vwgolf.org