Repairs to CAN bus wiring
An unshielded two-wire line -1-
and -2- with a cross section of
0.35 mm2 or 0.5 mm2
is used for CAN bus wiring.
The colour codes of the CAN bus wiring can be gleaned from
the following table:
  ...
Introduction
This chapter contains information on the following subjects:
→ The dangers of assuming an incorrect sitting position
→ Correct sitting position
→ Mechanical controls on the front seat
→ Electrical controls on the front seats
→ Adjusting ...
Checking fuel delivery rate, vehicles with four-wheel drive
Special tools and workshop equipment required
Removal wedge -3409-
Remote control for V.A.G. 1348 -V.A.G 1348/3A-
Multimeter e.g. hand-held multimeter -V.A.G 1526E-
Test instrument adapter/DSO (5-pin) -VAS 5565-
...